Cars with front passenger airbag off indicator lamp "K145"
Remove the front passenger airbag off indicator lamp "K145" "2".
Cars without front passenger airbag off indicator lamp "K145"
Insert wedge -VAS 3409- "1" in the middle under plug "2". Hit wedge -VAS 3409- with the palm of your hand to release the plug locks.
All
Unscrew screws "1" and "2" (1.5 Nm).
For clarity, the front panel is not shown in the figure. When performing the work described below, on the right side of the overlay, it is necessary to press the brackets "1" and "2". On the left side, it is necessary to press the brackets "3" and "4" accordingly.
Install the plates of the four round deflectors horizontally. Insert two fingers into the holes next to the hazard warning light switch and push the trim into the passenger compartment a little. Insert the wedge "3409" opposite the middle plate of the deflector into the gap formed between the trim and the front panel. Having unlocked the corresponding lock, carefully press the trim away from the front panel in this place. Similarly, unlock the lower lock of the "arrow" panel.
Pull the panel towards the front passenger and unlock the two fasteners (brackets) on the opposite side using the method described above. Without distorting, remove the trim "1" from the front panel.
Instructions: Do not allow the panel to become skewed.
Disconnect the wiring harness from the hazard warning light switch.
Installation
When removing the decorative trim, metal brackets "1" and "2" may come off. Find the brackets that have fallen inside the front panel so that they do not make extraneous sounds while driving in the future. Install the found brackets in their original places. If the fallen brackets cannot be found, install new brackets "№ 5M0 819 055".
Installation is carried out in reverse order.
Visitor comments