Front panel height adjustment
Instructions: The front panel is adjusted upwards using eccentric screws "3" and "4". In the so-called "zero position", the eccentric protrusion is directed outwards from the car. The eccentric screw cannot be turned more than ±900 from the zero position.
Adjust the front panel vertically using eccentric screws "3" and "4".
[The original article is posted on the website: VWManual.ru]
Adjusting the transverse position of the front panel
Caution: To prevent damage, do not go beyond the highlighted areas in the illustration when performing the front panel adjustments described below.
Move the front panel to the proper position, without going beyond the areas "A" and "B" highlighted in the figure.
After installing the front panel in the proper position, secure it by tightening the fasteners to the prescribed torques. Installation of removed parts and units is carried out in the reverse order.
Visitor comments