Removal and installation the rear end panel trim
Remove the cargo flooring from the vehicle. Remove the spare wheel from the vehicle. Remove other parts from the luggage compartment. Using a hexagonal socket (3 mm), unscrew the rod "1" and remove the expansion piston "2" using the puller "T10236". Remove the second piston "3" in the same manner.
Pull the trim in the direction of vehicle movement so that the lugs are inside "arrow A". Using a movement in the direction of "arrow B", remove the trim from the mounting holes in the end panel.
Removal and installation the side trim of the luggage compartment
Instructions: The work on removing and installing the left side of the car is described below. The work on removing and installing the right side of the car is carried out in a similar manner.
Remove the cargo flooring from the vehicle. Remove the spare wheel from the vehicle. Remove the other parts located in the luggage compartment from the vehicle. Remove the rear end panel trim. Unscrew screw "1" (1.5 Nm) from the side trim of the luggage compartment. Remove bracket "2" (a plug can be installed instead).
Unscrew screw "1" (1.5 Nm) located in the rear shelf socket.
If present, unscrew fastening element "1" (8 Nm).
Unscrew screw "1" (1.5 Nm).
If present, unscrew screw "1" (8 Nm) and remove eye "2".
Disconnect trim "1" from the side panel and disconnect the wiring harnesses of the luggage compartment light "W3" and the socket from it.
The original article is available on the website: www.VWManual.ru
Visitor comments