Removing and installing the drawer nest
Drawer nest (option) is installed on the following types of seats: front seat with manual height adjustment, front passenger seat with backrest folding mechanism for transporting long loads.
Press locking tabs -1- on left and right outward, then remove drawer -2- from the seat. Unscrew the two screws -3- and -4- (8 Nm). Pull the drawer socket -5- out of the mounting sockets in the seat frame.
Removing and installing front seat heating control unit -J774-
Instructions: The control unit is installed in front under the seat.
Switch off the ignition. Disconnect wiring harness -1- from control unit -2-. Turn the control unit clockwise and detach it from the seat frame.
Removing headrest guides
Instructions: For clarity, the figures show the removed head restraint guides.
Position seat repair bracket -VAS 6136- on stand -VAS 6095-. Remove the front seat. Attach seat to bracket -VAS 6136-. Remove the front seat belt buckle. Remove lining from tunnel side. If present, remove the lumbar support adjustment lever.
Front passenger seat without height adjustment
Remove the backrest adjustment knob. Remove trim from sill side.
Front passenger seat with backrest folding mechanism for transporting long loads
Remove trim from sill side.
Front seat with manual height adjustment
Remove the backrest adjustment knob. Remove trim from sill side.
Power driver's seat
Remove trim from sill side. Disconnect the two seat back actuator harnesses at the bottom of the seat frame. Remove the wiring harnesses from the seat frame.
All
Remove seat back. Attach backrest to bracket -VAS 6136-. If present, remove the folding table from the back. Remove the front seat cushion and upholstery. Unlock lock -arrow A- for head restraint guide with button -1- inside the frame. Remove the head restraint guide with button from the seat back. Unlock lock -arrow B- inside frame for second head restraint guide -2-. Remove the head restraint guide from the seat back.
Removal and installation of a back of a seat
Instructions: The following describes the removal and installation work on the left side of the car. Removal and installation work on the right side of the car is carried out in the same way.
Position seat repair bracket -VAS 6136- on stand -VAS 6095-. Remove the front seat. Attach seat to bracket -VAS 6136-. Remove the front seat belt buckle. Remove lining from tunnel side.
Front passenger seat without height adjustment
Remove the backrest adjustment knob. Remove trim from sill side.
Front passenger seat with backrest folding mechanisms for transporting long loads
Remove trim from sill side.
Front seat with manual height adjustment
Remove the backrest adjustment knob. Remove trim from sill side.
Power driver's seat
Remove trim from sill side. Disconnect the two seat back actuator harnesses at the bottom of the seat frame. Remove the wiring harnesses from the seat frame.
All
Cut the shielded cable ties, disconnect and pull out the side airbag wiring harness.
Instructions: The removal and installation of the backrest is described using the manual seat as an example. For a power seat, removal and installation are carried out in the same way.
Unscrew the left and right two screws -1- and -2- (34.5 Nm). Remove the backrest from the seat frame.
Visitor comments