Note: Removal and installation on an IBIZA vehicle is basically the same. The door lock, power window and loudspeaker are fixed on the holder of the door mechanisms. The door lock can only be removed together with the door mechanism holder.
Removing
Remove door trim see relevant chapter above.
Remove lock cylinder see previous chapter.
Unfasten the clamp from the door handle, see relevant chapter above.
Remove the door mechanism holder, see relevant chapter below.
Using a punch, knock out clips -1- of locking bracket.
Using a screwdriver, press out insert -1- for cable tie -2- and insert -6- for locking rod -5-.
Using a screwdriver -3-, press the lock -4- together with the locking bracket -7- from the holder of the door mechanisms.
Note: The locking bracket is attached to the door lock with a screw and rivet.
Turn locking rod -1- in direction of arrow and unfasten. Rear door lock: turn the door lock and release the locking rod.
Detach cable tie -2- from holder. Turn cable tie nipple by 90°and remove from eye.
Installation
Install the lock on the door mechanism holder.
Pull lock lever -1- in direction of arrow.
Use a screwdriver -3- to compress the lock spring -2- in the direction of the arrows and hook it onto the lock lever.
Attention: As a result of hanging the spring on the lock lever, the lock is locked. This prevents further «wrong» cable tie fastening.
Further installation is carried out in the reverse order.
With the door open, check the operation of the locking mechanism.
Visitor comments