Removing
Remove lock cylinder see next chapter.
Release clip -1- and tilt handle -2- away from the door. 3 - lock drive lever.
Installation
Insert special tool -1- through the hole at the end of the door VW-T10118 (arrow -A-) and hook the spring -2- (-arrow B-).
While pulling out tool in direction of arrow -C-, attach spring -2- to door lock.
Tilt the door handle towards the door.
Pull the clip -1- into the leaf opening and fix it in the door handle -2-. At the same time, press the handle against the door.
Attention: Do not pull on the lock lever -3- when installing the clip, see figure N57-0214.
Install the lock cylinder see next chapter below.
With the door open, check the operation of the locking mechanism.
Visitor comments