Contents: Removal ↓ Installation ↓
Removal
Release the cover at the rear of the guide rail and remove it by sliding the cover backwards.
Move the seat forward.
Unscrew the cap nut 4 (figure 468) seat support. Remove the cylindrical head screw 1.
Release the locking rod 3 and slide the seat back out of the runners.
Installation
Attention! If before removing the seat there was difficulty in moving it in the longitudinal direction or significant play, it is necessary to check the runners 2 (see figure 468). If in doubt, compare with new skids and replace if necessary.
Figure 468. Front seat fastening elements: 1 - cylindrical head screw, 2 - slide; 3 - locking rod; 4 - cap nut
Insert the seat from the back into the runners and slide it forward.
Insert the cap screws, apply the retaining ring and tighten the cap nut to a torque of 1.5 Nm.
Install the locking rod with the spring.
Install the overlay.
Visitor comments