Contents: Removal ↓ Installation ↓
On vehicles produced since August 1987 with electric drive for outside rear-view mirrors, remove and install them in the manner described below.
Removal
Fix the mirror glass. To do this, turn the lock handle counterclockwise with a screwdriver (toothed disk under the lower edge of the mirror glass).
Carefully remove the mirror glass and disconnect the electrical wires.
Remove the mounting screws (figure 462) and remove the mirror control motor.
Disconnect the electrical wires and label them.
Pull out the mirror position switch from the door trim and remove it.
Disconnect the connector.
Remove the door trim.
Remove the protective film from the wire connection area.
Release the wire fastenings and disconnect the wire connectors, marking their connectors.
Installation
Connect the mirror installation motor in accordance with the color markings.
Turn the lock on the mirror glass counterclockwise until it stops and carefully insert the glass into the mirror housing.
Fix the glass with the retainer. To do this, turn the retainer clockwise with a screwdriver.
Connect the electrical wires and secure them.
Carefully and without creases, glue the protective film with double-sided adhesive tape.
Install the door trim.
Connect the connector and set the switch.
The original information is posted on the website [www.VWManual.ru]
Visitor comments