Change the oil filter as directed in the owner's manual or at any engine repair. To dismantle the filter, use the filter change wrench and tap on the side of the filter with a screwdriver and. using the handle as a lever, unscrew the filter.
If the filter base is unscrewed from the motor, a new seal must be used during installation. Tighten the filter base screw to a torque of 25 Nm. Do not lubricate the seal with grease.
Filter installation instructions are printed on a sticker on the filter. Slide a new rubber O-ring onto the flange, making sure to lightly grease it. Screw in the new filter by hand - do not use any tool.
Finally, check and, if necessary, correct the oil level.
Visitor comments