Instructions: In order to remove the windshield wiper linkage with rods and the windshield wiper motor, you must first remove the wiper arms and the lining of the water drainage box.
Remove the "arrow" caps by carefully prying them off with a screwdriver.
Loosen the nuts "arrows" and unscrew them. Install the puller -T10369/1- "2", as shown in the figure, on the end of the lever "4". Unscrew the stop element "3" until the end of the thread appears and remove the lever by turning the screw "1" clockwise. Repeat these steps with the second lever.
Removal the wiper linkage with rods and wiper motor
(The article is published on this resource: www.vwmanual.ru)
Unlock and disconnect the plug connector "1". Unscrew the fastening screws "arrows" and pull the wiper linkage with the motor "2" out of the side of the car.
Visitor comments