Contents: Dismantling ↓ Installation ↓
Dismantling
Please note: The central lock can be removed and inserted with the sliding door installed and open.
(1) central locking
(2) Hexagon bolts M8x40, tightening torque 21-25 Nm
(3) wire traction
(4) lock washer
(5) rear adjacent surface of sliding door
(6) Foam Traction Pad
Remove the sliding door trim.
[The information is presented on the website: www.VWManual.ru]
(58-240) remove lock washer 4 from rod.
Remove the wire rod 3 from the remote control lock pin.
Unscrew bolts 2, see Fig. 58-239.
Remove the central lock together with the rod, separate the lock washer 4 from the wire rod 3 and from the central lock, see Fig. 58-239.
Installation
Attach the wire rod to the central locking pin and secure it with a washer.
Push the rod into the door and place the foam pad 6 on the rod 3, see Fig. 58-239.
Tighten the lock to the door with a torque of 20.7-25.3 Nm.
Attach the rod to the remote control lock pin and secure it with a lock washer. Glue the pad on the rod in the middle of the door.
Visitor comments