Car clutch repair VW Transporter T4

Clutch — design description
Clutch 1. Flywheel - the friction surface of the friction linings should not be greasy, not oily, without scratches. Pay attention to the reliability of the guide pins 2. Bolt –...

General clutch data
The clutch is designed to briefly disconnect the engine from the gearbox when shifting gears and ensures smooth starting. The clutch consists of a pressure leading disk, a driven...

Removal, installation and checking the clutch
Removal 1. Remove the gearbox (see subsection 4.2 ). 2. Loosen the pressure plate mounting screws sequentially by 1–1½ turns each time until the pressure plate is loose. Caution!...

Bleeding air from the clutch drive
For hydraulic clutch only It is necessary to release air from the drive only if the clutch pedal does not return to its original position or returns with a delay, or the hydraulic...

Replacing the clutch cable
Removal 1. If the clutch cable is to be installed again, the adjusting mechanism must be compressed and held in the compressed position with a locking band. For this purpose, if...

Diagnosing Clutch Faults
Cause Method of elimination The clutch is jerking Idle speed too low Adjust the speed Engine and gearbox bearings have failed Check and replace if necessary The gearbox suspension...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Transporter T4 Transporter T3