Petrol car ignition system VW Transporter T3

Ignition system — general information
The ignition system produces an ignition spark that ignites the air-fuel mixture in the cylinders. To produce an ignition spark of sufficient power, the ignition coil converts the...

Safety precautions when working with the ignition system
To prevent injury to workers and/or damage to the ignition system, the following rules must be observed: When the engine is running or when starting it, do not touch or disconnect...

Operation of the transistor ignition system TSZ-H
The transistor ignition system with a Hall sensor is a contactless ignition system. Instead of the breaker contacts, a maintenance-free Hall sensor is installed in the ignition...

Digifant Ignition and Fuel Injection System
The Digifant ignition and fuel injection system combines the ignition and fuel injection functions in one control unit. The control unit has the task of implementing parametric...

Checking the ignition coil
The ignition coil is checked using an ohmmeter. Disconnect the ground wire from the battery. Remove the ignition coil cover. Disconnect the wires from the ignition coil. If the...

Checking high-voltage wires and spark plug tips
Check the ignition system wires as a set. If there are any deviations from the specified values, check the wires separately. Check the tip with radio interference filter "3"....

Removal and installation the ignition distributor
Complete removal of the ignition distributor is only required for major repairs or when disassembling the engine. Removal Use a screwdriver to press the clamps on the distributor...

Removal and installation the ignition distributor drive shaft
Removal Set cylinder 1 to top dead center position. Remove the ignition distributor. Remove the fuel pump. Remove the spring from the drive shaft. Pull out the drive shaft using...

Checking and adjusting the ignition timing
The ignition timing needs to be adjusted only after removing the ignition distributor or performing work on the distributor ignition, since the transistor ignition system;...

Connecting the switching unit of the idle speed stabilization system
The Digital Idle Stabilization (DLS) system is installed on the following engines: engines with MV indexes (1.9 l/44 kW), DJ (2.1 l/82 kW) and GW engines (1.9 l/66 kW) release...

Checking the TSZ-H ignition system switching unit
Test conditions: Ignition coil and DLS system are normal. Disconnect the idle speed control system switching unit connectors and connect them together, see Figure 28-101....

Checking the Hall sensor
Test conditions: The ignition system switching unit is functioning normally, the connection between the ignition system switching unit and the ignition distributor is normal....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Transporter T4 Transporter T3