Checking high-voltage wires and spark plug tips (VW Transporter T3)

Check the ignition system wires as a set.

If there are any deviations from the specified values, check the wires separately.

Check the tip with radio interference filter "3". Specified value: 1±0.4 kΩ.

Check spark plug tip "1". Specified value: 5±1 kom.

Check ignition wire "1". Specified value: 0 ohms.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text has been checked: Tarasov Ivan

Previous articles
Checking the ignition coil
Digifant Ignition and Fuel Injection System
Operation of the transistor ignition system TSZ-H
Safety precautions when working with the ignition system
Ignition system — general information

Next articles
Removal and installation the ignition distributor
Removal and installation the ignition distributor drive shaft
Checking and adjusting the ignition timing
Connecting the switching unit of the idle speed stabilization system
Checking the TSZ-H ignition system switching unit
Checking the Hall sensor

Similar articles from other manuals for VW cars:
Checking high voltage wires Passat B3 (1988-1993)
Checking the distributor rotor, wires, spark plug tips Golf 2 (1984-1993)
Ignition coil, spark plug wire tip (since 10.1999) Polo 3 (1995-2003)
Checking the battery open circuit voltage Touareg 1 (2002-2006)
Relieving pressure in the high pressure area of the fuel system Tiguan 1 (2007-2015)
Checking the engine oil level and replacing it Sharan 1 (1995-2000)
Spark plugs and spark plug wires — general information LT 28 (1975-1991)

Checking high-voltage wires and spark plug tips (VW Transporter T3)

Visitor comments