Removal and installation the lock cylinder (VW Transporter T3)

Dismantling

(57-126) open the door, remove the door seal, unscrew the screw (arrow).

Remove the door handle.

If you need to remove the lock cylinder, pull the pin out of the cylinder.

Caution: Use caution when handling small springs.

Attention! Before removing the cylinder from the door handle, insert the key, otherwise the plates will fall out.

If the key is pulled out of the cylinder, you need to wrap the cylinder with adhesive tape.

Installation

Insert the cylinder into the door handle.



Place and tighten the spring by lifting one end of the spring above the protrusion in the lock (arrow).

Place the fork. The fork protrusion should be between the ends of the spring, and the fork should sit completely on the square.



Insert the pin into the square.

Install the door handle with the lining and screw it in place.

Sliding door lock

(58-222) Note: Before installing the outer sliding door handle, use the key to turn the locking pin (arrow) so that it enters inside, otherwise the lock cylinder may be damaged.