Contents: Removal ↓ Installation ↓
Removal
Pry the plug out of the lower hole a, then pull the plug down b (Fig. 8.28).
Pull door handle 1 and hold it. Unscrew bolt 3 using socket wrench T 10072 until it stops. This will release the lock cylinder housing 2 (Fig. 8.29).
If the lock cylinder housing does not contain the lock cylinder itself, you can remove the lock cylinder housing 2 at a right angle to the door from the door handle mount.
If the lock cylinder housing contains a lock cylinder, it is necessary to loosen the fixing screw 3 so that this housing 2 can be removed at a right angle from the door handle mount.
Installation
Insert the lock cylinder body at a right angle into the door handle mount.
Now use a socket wrench to tighten the bolt into the mount.
A distinct click indicates that the door handle has been re-locked into the lock cylinder housing.
NOTE: During installation, the lock cylinder body should be pressed against the outer door trim from the inside. The door handle is not installed tightly on the door.
Then the installation is carried out in reverse order.
Finally, it is necessary to check the operation of the door handle and lock, since if the flexible cable is not adjusted and fixed correctly, the door may not open.
The original can be seen on the portal: vwmanual.ru
Visitor comments