Electrical equipment and devices of car Volkswagen Passat B3

Removal and installation the instrument panel
Note: The picture shows the instrument cluster with an analog clock 1 - protective glass 2 — fuel reserve indicator 3 - indicating device For temperature and low coolant level. 4...

Removal and installation the tachometer shaft cover
The tachometer shaft is inserted from the back of the instrument panel. In the installed position, the tachometer shaft is fixed by a compression spring on the water drainage...

Removal and installation the printed circuit board
Up to 7/90 Removal Remove the instrument panel. Remove the instruments. Unscrew the 2 screws securing the pressure sensor and remove the sensor. Remove the contact plate for the...

Location of instrument panel terminals
Up to 7/90 Multi-pin plug connector for instrument cluster Note: To check the multi-pin connector on the printed circuit board, you only need to remove the instrument on the left;...

Checking the voltage stabilizer
The voltage stabilizer equalizes the working voltage for the indicating devices. The voltage stabilizer should be checked when the fuel reserve and coolant temperature indicators...

Replacing LEDs
Remove the instrument panel. Remove the LED cover. Remove the LED. A specialized workshop uses a VAG-1315A digital multimeter for testing. Press the resistance and voltage...

Removal and installation the steering column switch
Removal If equipped, remove the airbag assembly, see chapter " Steering ". Steering wheel without airbag: remove the steering wheel cover. To do this, lift the cover from below...

Removal and installation the steering wheel shaft lock housing
Removal Remove the switch on the steering column. Remove the lock washer, spring and contact ring from the steering column. Remove the screw securing the steering wheel shaft lock...

Removal and installation steering column trim
Removal Remove the steering wheel, see chapter " Steering ". Unscrew the 2 screws securing the trim at the bottom. Installation Please note: From 4/89 the trim parts have...

Removal and installation the ignition lock cylinder/steering wheel shaft
Removal Remove the switch on the steering column. Mark the steering wheel shaft lock housing for drilling a hole: a = 12 mm, b = 10 mm. Drill into the steering wheel shaft lock...

Removal and installation radio
The factory-installed radio is equipped with a mount with guides that allow for quick installation and removal of the radio. First of all, this can only be done immediately with a...

Entering the radio code
Only applies to VW - radio with coding The coding of the anti-theft system prevents its unauthorized disconnection in the event of a power failure. A power failure occurs, for...

Removal and installation the antenna
As a rule, the VW PASSAT is equipped with a rear antenna. The wire heating element of the rear window is also used for radio reception. For this, an additional antenna amplifier...

Removal and installation the roof antenna
1 - antenna rod 2 - antenna base The antenna amplifier is built into the base of the antenna. To remove, pull the dome back. 3 - antenna wire From the antenna to the A-pillar,...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar sections from other manuals for VW cars:
Electrical equipment: Equipment and devices Volkswagen Golf 1 (1974-1984, diesel)

Passat B6 Passat B5 Passat B4

Passat B3 Passat B2