Contents: Removal ↓ Installation ↓
Up to 7/90
Removal
Remove the instrument panel.
Remove the instruments.
Unscrew the 2 screws securing the pressure sensor and remove the sensor.
Remove the contact plate for the Hall sensor or inductive sensor by unscrewing 2 screws.
Compress the expansion pin "1" of the terminal block fastening on the printed circuit board and carefully remove the terminal block with the printed circuit board.
Caution: Do not damage the printed circuit board.
[The original article is available at: www.VWManual.ru]
Press the locking tabs in the direction of the arrows and pull the plug connector out of the housing.
Installation
Insert the plug connector and secure it.
Place the terminal panel with the printed circuit board and secure it.
Place the printed circuit board onto the contact plate without gaps and secure it from shifting.
Press the contact plate under the tachometer shaft connection point and screw it on.
Note: The contact plate presses the threaded printed circuit board against the spring-loaded sensor contact on the back of the speedometer.
Screw on the pressure sensor for MFA.
Install the devices.
Install the instrument panel.
Visitor comments