Contents: Removal ↓ Installation ↓
Removal
Remove the wheel.
Remove the coil spring.
Hang the speed sensor wire on the upper control arm.
Fig. 4.69. Subframe eccentric bolt
Mark, for example with a felt-tip pen, the position of the eccentric bolt relative to the subframe (Fig. 4.69).
Unscrew the bolt.
Remove the upper control arm.
Installation
Insert the upper control arm into the vehicle and tighten the bolts finger tight.
Tighten the transverse arm only when dimension "a" is reached.
Bolt the upper control arm to the subframe and tighten the new nut.
Pay attention to the marking of the position of the eccentric bolt relative to the subframe.
Tighten bolt 1 of the upper control arm.
Note: Make sure there is a washer between the bolt and the wheel bearing housing.
The article is posted on this website: www.VWMANUAL.ru
Secure the speed sensor wire to the upper control arm.
Install the coil spring.
Install and tighten the wheel.
Adjust the wheel alignment angles.
Visitor comments