Removing
Loosen the driveshaft hex bolt.
Remove the wheel.
Remove the caliper with bracket and hang on a wire to the body.
Remove the ABS speed sensor.
Remove the brake disc.
Press the drive shaft as far as possible out of the wheel hub (towards the gearbox).
Unscrew the bolts.
Remove the wheel bearing module from the bearing housing.
Installation
Installation is carried out in the reverse order.
Install the support.
Tighten the driveshaft hex bolt.
Note: When doing this, the vehicle must not be on wheels, otherwise the wheel bearing will be damaged.
Install the ABS speed sensor.
Visitor comments