Contents: Removal ↓ Installation ↓
Removal
Remove the drive shaft hex bolt.
Remove the wheel.
Unscrew the nuts.
Pull the drive shaft slightly out of the wheel hub.
Remove the hinge from the lever.
Tilt the lever down as far as necessary.
Fig. 4.45. Pressing out the ball joint
Install the ball joint puller as shown in Figure 4.45 and press out the joint.
Note: Use an engine and transmission stand or similar (risk of injury due to falling parts when pressing out the hinge).
Note: To protect the threads, leave the nut on the hinge, tightening it a few turns of the thread.
Installation
Insert the joint into the wheel bearing housing.
Insert the drive shaft into the wheel hub.
Screw on new self-locking nuts, using the internal Torx as a counter-support.
Tighten the nuts.
Note: Check the boot for damage and twisting.
The original can be viewed on the portal: www.VWmanual.ru
Note: Install and tighten the wheel, tightening torque.
Note: Tighten the drive shaft hex bolt.
Note: The vehicle must not be standing on its wheels, otherwise the wheel bearing will be damaged.
Visitor comments