Front axle
1. Upper knuckle; 2. Right torsion bar; 3. Shock absorber; 4. Right axis; 5. Bracket for attachments; 6. Lower knuckle; 7. Left tie rod; 8. Upper axial hinge; 9. Wheel bearing
Front suspension
1. Nuts, 160 Nm; 2. Shock absorber; 3. Remote tube; 4. Bottom support ring; 5. Screw, 100 Nm; 6. Shock absorber support; 7. Top support ring; 8. Washer; 9. Nut, 25 Nm; 10. Nut, 100 Nm; 11. Buffer; 12. Nut, 110 Nm; 13. Lower knuckle; 14. Air vent; 15. Nut, 160 Nm; 16. Front support sleeve; 17. Hex screw M14x1.5x82; 18. Eccentric screw M12 or M14; 19. Rear support sleeve; 20. Eccentric washer; 21. Nut M12 x1.5 or M14x1.5. Attention: depending on the thread, different tightening torque: M12 - 75 Nm 90°additional tightening, M14 -160 Nm; 22. Lower knuckle; 23. Connecting rod; 24. Hex screw; 25. Nut, 110 Nm; 26. Eccentric washer; 27. Eccentric sleeve; 28. Upper axial hinge; 29. Upper knuckle; 30. Retaining ring; 31. Nut, 100 Nm; 32. Front support sleeve; 33. Hex screw M12x1.5x80; 34. Rear support sleeve; 35. Nut, 100 Nm; 36. Hex screw M14x1.5x42; 37. Hex screw, M14x1.5x30; 38. Nut, 160 Nm; 39. Torsion; 40. Torsion lever; 41. Torsion nut; 42. Torsion bar adjusting screw; 43. Hex screw, 160 Nm M14x1.5x40; 44. Hex screw, 100 N·m M12x1.5x32; 45. Screw, 55 Nm; 46. Collar; 47. Stabilizer bushing; 48. Stabilizer; 49. Rubber support; 50. Screw, 55 Nm; 51. Rubber-metal support; 52. Weld nut; 53. Mounted bracket C 8/92 (FG №70РН004343)
Attention! Attachment bracket С 8/92 (FG №70РН004343) a bracket for mounted units with a modified design of the rear gearbox support is installed. This attachment bracket cannot be installed on older machines prior to this date.
Attention! Since 11/91 (FG №70M083342) changed the eccentric screw for adjusting the longitudinal inclination of the kingpin from M12 to M14. In this regard, the elongated hole for adjusting the kingpin and the bushing of the rear rubber-metal bearing have also been changed from 12 mm to 14 mm. This applies to parts: 18, 19, 20, 21 and 53.
Visitor comments