Contents: How to clear ice from windshield and…↓ How to prevent fogging of windshield…↓ Ventilation (fresh air supply to the…↓ How to maintain a pleasant warmth in…↓ General instructions ↓
Heated or unheated air is supplied to the passenger compartment through all nozzles (depending on the position of handle A) air.
The distribution of air supply to the nozzles is determined by the position of handle C.
Additionally, nozzles 3 and 4 can be opened or closed separately.
The nozzle is closed: side dial on
.
The nozzle is open: side dial on
.
Depending on the position of the disc regulator, the air flow changes its direction in height.
If you turn the dial under the deflector grille, the direction of the air flow in the horizontal plane changes.
The nozzles 2 keep the lower part of the windshield free of fog.
How to clear ice from windshield and side windows
Set switch B to position 3.
Turn handle A clockwise until it stops.
Handle C on
.
Install nozzles 4 so that the air flow is directed to the side windows.
How to prevent fogging of windshield and side windows
If the windows fog up due to high humidity, for example during rain, it is recommended to do the following:
Set switch B to position 2 or 3.
If necessary, move handle A to the air heating zone.
Put the handle C on
.
Through nozzles 4, additional warm air can be directed to the side windows.
Ventilation (fresh air supply to the cabin)
With the control positions shown below, unheated fresh air is supplied from nozzles 3 and 4:
Set switch B to the desired level.
Turn handle A counterclockwise until it stops.
Handle C on
.
If the windshield fogs up, turn the knob C to
.
If desired, handle C can also be set to another position.
Open nozzles 3 and 4.
How to quickly increase the temperature in the cabin
Set switch B to position 3.
Turn handle A clockwise until it stops.
Put the handle C on
.
If the windshield fogs up, turn the knob C to
.
Nozzles 4 can be installed as desired.
How to maintain a pleasant warmth in the car interior
Once the windows have cleared of fog and the interior temperature has reached the desired level, it is recommended to do the following:
Set switch B to the desired level.
Set knob A to the desired heating level.
Set the C knob to the area between "Air flow to the footwell" and "Windshield and side window de-icing".
If the windshield fogs up, set the C knob to
.
Nozzles 4 can be installed as desired.
General instructions
In order for the interior heating and ventilation to work reliably, the fresh air intake opening located in front of the windshield must be kept free of ice, snow and leaves.
Only handles A and C can be set to any intermediate position.
To avoid fogging of the glass, at low vehicle speeds, switch B should be set to the lowest level of the fan mode, and switch C should be set to position
.
The heating capacity of the heating system depends on the temperature of the coolant in the engine cooling system – therefore, the greatest heating occurs when the engine is warmed up to operating temperature.
Used air is removed through outlets in the rear of the body; the outlets for used air should not be obstructed.
In a sedan, the gap between the luggage rack and the rear window, which serves to remove used air, must not be blocked with anything.
Visitor comments