Examination
Disconnect the throttle position sensor connector and check the resistance between the terminals of the sensor block (pic. 2-186) as shown in Table 2-29.
Adjustment
Open throttle slightly. In this case, a click should be heard from the operation of the sensor. If not, insert probe 1 (pic. 2-187) 0.10 mm thick between the throttle stop and the throttle control lever, loosen screws 2 securing the sensor housing. move the housing until it touches the lever and tighten the fastening screws. Remove the dipstick and verify that the click from the sensor occurs at the beginning of the throttle opening stroke. Connect the sensor connector.
Visitor comments