- 1 - protective cap
- 2 — cotter pin
Always replace.
- 3 - crown lock washer
- 4 - hex nut
To adjust the radial clearance in the bearing.
- 5 - pressure washer
- 6 — outer wheel hub bearing
Knock out the outer ring with a copper pin.
- 7 - Allen key bolt, 10 Nm
- 8 — rotation speed sensor
Only in vehicles with ABS.
- 9 — axle journal
Note: Straightening of the axle journal is not permitted.
- 10 - brake shield
Together with the axle journal, it is bolted to the rear axle.
- 11 — sealing ring
Fill the area between the working edges with universal grease.
- 12 - disc spring
The large support surface faces the brake shield.
- 13 - Hexagon head bolt, 60 Nm
- 14 — inner wheel hub bearing
Knock out the outer ring with a copper pin,
- 15 — rotor
Pressed in, only for vehicles with ABS.
- 16 - brake drum
Before removing the brake pads, remove them using the threaded hole under the wheel bolt. Before installing, fill the hub with universal grease.
[View the original on this portal: VWMANUAL.ru]
Visitor comments