Car models from 10/33
- 1 — lock cylinder body
- 2 - push button spring
- 3 - push button
- 4 - sealing ring
- 5 — lock cylinder
Caution: Only remove the lock cylinder with the key inserted.
- 6 - sealing ring
- 7 — guide cylinder
- 8 - lower part of the lock cylinder body
Removal: press the retaining ring "10". Press the retaining clip "11" outward.
- 9 - guide lever
- 10 - retaining ring
- 11 - locking bracket
Car models up to 9/93, with central locking system
- 1 - upper part of the lock cylinder body
Remove together with the bottom part
- 2 — lock cylinder
Removal: knock out the spring pin and remove the eccentric.
Caution: Do not lose the ball. Only remove the lock cylinder with the key inserted.
- 3 - sealing ring
- 4 - push button
To remove, remove the lower part of the lock cylinder housing.
- 5 - spring
- 6 - ball
Apply grease to the spring and ball before installation.
- 7 - push button spring
To remove, remove the lower part of the lock cylinder housing.
- 8 - lower part of the lock cylinder body
Removal: knock out the spring pin and remove the eccentric.
Attention: Do not lose the ball. Press the locking clip "11" outward.
- 9 - spring pin
- 10 - eccentric
When removing, be careful not to lose the ball.
- 11 - locking bracket
- 12 - plastic valve
Insert a screwdriver into the slot of the plastic valve, slightly open the clamp and pull out the drive rod.
- 13 — rod of the central locking system drive
When installing, insert the drive rod so that it is fixed in the valve clamp.
Visitor comments