Contents: Removal ↓ Installation ↓
Removal
Remove the inner door trim.
Remove the inner seal from the window glass edge.
Lower the window glass down and unfasten it from the window lifter.
Tilt the glass forward and pull it out of the shaft with an upward movement.
Installation
Note: If a new window glass is being installed, fit the window regulator rail onto it: dimension "a" must be 303 mm.
Place the window glass into the door shaft.
Raise the glass up and then lower it again until the screws are visible in the mounting holes "3".
Tighten the screws to a torque of 7 Nm.
Place the inner seal of the window glass onto the edge.
Install the interior door trim.
Visitor comments