Contents: Removal ↓ Installation ↓
Note: Special points regarding the driver's side door must be noted. Other actuators are removed and installed accordingly.
Removal
Remove the door trim.
Remove the inner door lock drive and the lock rod, see the section "Removing and installing the door lock". 9 Unclip the pipeline from the clamps.
Turn the hinge "4" on the actuator in the direction of the arrow (open) and press the connecting rod.
Loosen the 2 Phillips head screws and pull the actuator upward.
Disconnect the pipe and the electrical multi-pin plug connector.
Installation
Connect the electrical plug and the pipe connector until they lock into place.
Insert the actuator with pre-installed screws and screw it in tightly.
Lay the pipes in the door frame clamps.
When installing the connecting rod, the actuator and door lock must be in the locked position (down).
Note: The driver's door latch must be in the "closed" position, which can be done by turning the latch with your fingers or by closing the door.
The lock washer "5" must be fixed on both sides (arrows).
Press the connecting rod and lock the hinge.
(The original can be found at VWManual)
Caution: Do not pull the connecting rod downwards when pressing.
When locking, hinge "4" should rotate the lock washer and unlock.
Check the operation of the central locking system.
Install door trim.
Visitor comments