- 1 - Enclosure with soundproofing screen of noise damper
- 2 - Anti-noise insulation of intake air
- 3 - Air intake sleeve, fasten with spring clamps
- 4 - 7 Nm, self-tapping screw. Only tighten the fastening screw with a screwdriver. if the speed of the screw driver does not exceed 500/min and the tightening torque is not more than 7 Nm
- 5 - 7 Nm
- 6 - 7 Nm, self-tapping screw
- 7 - O-ring, replace
- 8 - Pressure pipe
- 9 - Noise isolation
- 10 - Enclosure for soundproof screen.
- 11 - Anti-noise insulation for charge air. With lip seal, replace lip seal between compressor and noise damper
- 12 - Compressor belt pulley
- 13 - 8 Nm
- 14 - Coolant pump with magnetic compressor clutch -N421-
- 15 - V-ribbed compressor belt. When installing the poly V-belt, pay attention to the direction of travel and the correct fit on the pulleys and tensioner
- 16 - 23 Nm
- 17 - Tensioner for compressor V-ribbed belt, loosen with a spanner of 16, secure with locking pin -T10060 A-
- 18 - 40 Nm and tighten by 90°. To loosen and tighten the mounting bolt, hold the compressor shaft with a wrench, replace
- 19 - Compressor
- 20 - 25 Nm
Visitor comments