Instructions: All hose connections must be secured with standard clamps corresponding to the model year. The hoses and hose fittings of the charge air system must be free of oil and grease before installation. Only the lip seals and sealing surfaces should be lightly oiled for nipple connections. The boost system must be airtight.
- 1 - Charge air cooler
- 2 - 5 Nm
- 3 - Support for intercooler
- 4 - Shaft seal, replace if damaged
- 5 - Charge air hose
- 6 - Intake manifold pipe with lip seal
- 7 - Throttle valve control unit -J338-. When replacing, delete values in memory and readjust engine control unit -J623-
- 8 - 7 Nm
- 9 - Hose clamp
- 10 - Charge air hose
- 11 - 10 Nm
- 12 - Charge air pipe
- 13 - Charge pressure sender -G31- with intake air temperature sender 2 -G299-
- 14 - 5 Nm
- 15 - Charge air supply hose to turbocharger
- 16 - Charge air pipe
- 17 - Charge air hose
Visitor comments