- 1 - Bolt of the intake air temperature sensor "G42", 5 Nm
- 2 - Intake air temperature sensor "G42"
- 3 - Solenoid valve 1 of the activated carbon absorber "N80"
- 4 - Intake manifold
- 5 - Vacuum reservoir for charge air regulating flaps
- 6 - High pressure pump bolts, replace, 10 Nm
- 7 - Fuel line nipple from the fuel tank
- 8 - Fuel pressure regulator "N₂76"
- 9 - High-pressure fuel pump, with fuel pressure regulating valve "N₂76". When installing the high-pressure fuel pump, it is necessary to prevent dirt from entering the fuel system. To install the high-pressure fuel pump, relieve the pressure in the fuel system, remove the fuel line to the fuel rail without skewing
- 10 - Roller tappet, remains if necessary after removing the high-pressure fuel pump in the cylinder head, removable
- 11 - High pressure fuel line connecting nipple, replace, 22 Nm
- 12 - Fuel line to the fuel rail (Rail), install the fuel line without tension, 18 Nm
- 13 - Intake manifold flap valve "N316"
- 14 - Injectors, replace O-rings, ensure correct installation position
- 15 - Double check valve, with electromagnetic valve 1 activated carbon absorber "N80" single unit
- 16 - Intake manifold support
- 17 - Screw for intake manifold support, 23 Nm
- 18 - Fastening nut for intake manifold support, 10 Nm
- 19 - Throttle body bolts "J338", 4 pcs., 5 Nm
- 20 - Throttle valve unit "J338", throttle valve drive "G186". Throttle valve drive angle sensor 1 "G187" and throttle valve drive angle sensor 2 "G188", after replacing the throttle valve module "J338" it must be re-adapted to the engine control unit "J623"
- 21 - O-ring, replace. The ear of the O-ring must fit into the groove provided in the intake pipe
(View the original on the website vwmanual.ru)
Visitor comments