- 1 - Plug, replace if damaged
- 2 - Screw
- 3 - Earth connection, check the security of fixation
- 4 - Ventilation line to the absorber, check the reliability of fixation
- 5 - Retaining ring, 110 Nm, check secure fit. Remove and install using the key for the fuel level sensor -3087
- 6 - Fuel supply module, install in the correct position on the tank. With fuel gauge sender -G-, clean mesh if necessary
- 7 - Pressure line, black, clipped to the side of the fuel tank, check for secure fit
- 8 - Fuel level sender 2 -G169-, with jet pump
- 9 - 3.5 Nm
- 10 - Bracket for fuel pump control unit -J538-
- 11 - Fuel pump control unit -J538-
- 12 - O-ring, if damaged, replace, install dry in the opening of the fuel tank, when installing the flange, moisten with fuel
- 13 - Fuel tank
- 14 - 25 Nm, replace. To fix the clamps for fastening the fuel tank, it is allowed to use only bolts with washers turning on them. When using other bolts, the clamps may warp when tightened.
- 15 - Clamp, install in proper position
- 16 - 25 Nm, replace
- 17 - Clamping washer
- 18 - Heat shield
- 19 - Ventilation line, clipped to the side of the fuel tank, check the fixation
- 20 - Ventilation line, check the security of fixation
- 21 - 8 Nm and tighten by 90°, replace
- 22 - Filler cap, with rubber sheath
Mounting position of fuel delivery unit flange and fuel gauge sender 2 -G1 69-
Fuel supply unit -3-: tongue -1- faces direction of travel.
Fuel level sender 2 -G169-2-: tab -1- faces direction of travel.
Instructions: Ignore the arrows marked on the round nuts.
Visitor comments