Contents: Removal ↓ Installation ↓
Removal
Remove the support bracket.
Carefully secure the lower part of the clutch pedal in a vice with protective jaws.
Disconnect the clutch pedal from the master cylinder.
Fig. 3.11. Removing the servo spring
Remove the servo spring from the clutch pedal 1 and at the same time move the support bracket in the direction of arrow 2 (Fig. 3.11).
Carefully release the spring compression pliers.
Return the support bracket to its original position and remove the servo spring.
Installation
The clutch pedal is disconnected from the master cylinder.
Carefully secure the lower part of the clutch pedal in a vice with protective jaws.
Install the servo spring into the support bracket.
Fig. 3.12. Location of the trunnion mounting area
The attachment area of the clutch pedal pin A must be positioned vertically (Fig. 3.12).
Place the puller on the middle part of the servo spring and lift the support bracket.
[The text is copied from this portal VWMANUAL.ru]
Compress servo spring 1.
Fig. 3.13. Servo spring compression
At the same time, lower the support bracket so that 2 can press the servo spring against the seat neck A of the clutch pedal (Fig. 3.13).
Caution: If the servo spring is not installed correctly, it will pop out of the support bracket.
Caution: Cover the spring with a rag.
Caution: Check the operation of the servo spring.
Note: To do this, raise and lower the support bracket several times.
Connect the clutch pedal to the master cylinder.
Install the support bracket.
Visitor comments