Diesel engine
If the removed spring plate (front exhaust pipe and exhaust manifold mounts) it is necessary to loosen and stretch a new one for installation, then this is done in a vice as follows.
Weakening
1. Position the spring plate on the vise so that the wedge is in the 15 mm gap of the vise jaws with the impact side.
2. Carefully knock out the wedge with a plastic hammer down.
Stretching
3. Position the spring plate on the 15 mm open vise jaws as shown in the figure.
4. Drive the long wedge VW-3140A/1 or HAZET 2586N-1 into the spring plate with a plastic hammer until it stops. In this case, the vise jaws must be separated by approximately 15 mm.
Attention! If the spring plate with a long wedge is not installed due to poor access, drive in a short wedge 3140A/2 next to the long one (HAZEN: 2586N-2). Then turn the spring plate over and knock out the long wedge while the short wedge remains in place. Pay attention to the fact that after knocking out the long wedge, the short wedge lies on one of the vise jaws.
Visitor comments