- 12V 60/55W - High beam/fog lights.
- 12V 21W - Direction indicators.
- 12V 21W - Brake lights.
- 12V 5W - Clearance light.
- 12V 4W - Parking light.
- 12V 5W - License Plate Light.
High beam headlight bulb and parking light bulb
Raise the hood. Move the latch in the direction of the arrow and remove the cover. On some models, you must remove the cover before replacing the right headlight bulb.
After replacing the bulb, replace the two-lug cover and install it so that it snaps into place.
Remove wiring connector A. Unhook spring clip B and lower it down. Remove bulb 1 and insert a new one so that the tabs on the bulb fit into the grooves in the reflector. Secure the spring clip, connect the wiring connector. Check the headlight adjustment.
Rear lights
On Kombi cars: open the flap in the pocket. On Van cars: remove the cap of the socket.
Press the spring clips in the direction of the arrows and remove the socket. Remove the faulty bulb, insert the new bulb and turn it all the way to the right. Install the socket and secure it with the spring clips.
License plate light
Unscrew the housing of the flashlight 1. Holding the socket 2 with your hand, press the latches in the direction of arrow 3. Remove the housing of the flashlight in the direction of arrow 4. Replace the bulb and install the flashlight.
View the original on this portal [VWMANUAL]
Visitor comments