If the tank empties during the trip, it is not necessary to remove air from the system, as this happens automatically when the engine is started by the starter.
Attention: If there are difficulties with starting, in order to check whether fuel is supplied to the injectors, loosen the union nuts at two nozzles and start the engine without turning on the glow plugs until the fuel flows through the union nuts. Tighten the union nuts and start the engine in accordance with the instructions.
Attention: If the air from the power supply system is not automatically removed, then proceed as follows:
- Fill injection pump with diesel fuel.
- Fill the fuel filter with diesel fuel.
- Turn on the ignition and tow the car.
Thanks to these measures, the rapid removal of air from the supply system is guaranteed.
When working on the injection system, follow the instructions for cleanliness, see chapter «Supply system».
Also, make sure that diesel fuel does not get into the coolant hoses. In this case, the hoses must be cleaned immediately. Damaged hoses must be replaced.
Visitor comments