Gearbox assembly 020, 4-speed (VW Golf 2)

1. It is necessary to act according to the description of point 17 due to the fact that the boxes are similar.

2. If the ball bearing has not been installed before, it must be installed into the input shaft main body together with the original spacer washer (if it was installed).

3. The remaining actions must be performed in the reverse order of disassembly.

4. Install the left drive flange, then the spring washer, retaining clip and plastic plug.

5. With the forks in neutral position, install the shaft, spring and oil deflector. Tighten the end nut to the appropriate torque.

6 Install the reversing light switch.

7. Screw in and tighten the selector shaft fixing bolt to the appropriate torque.

The original text can be found at VWmanual.ru

8. Install the clutch release bearing and guide sleeve. The clutch release shaft, clutch lever and return spring can then be installed. The bent ends of the spring should fit into the housing and into the central bridge that engages the clutch lever.

9. Install the spring rings of the shut-off shaft. 10. Put on a new cover gasket and screw on the cover.

11. In the installed gearbox, it is necessary to engage all gears in turn and check that they are engaged correctly.