Instruction: Apply grease -G 000 450 02- to joints and sliding surfaces. Do not bend drive cables!
- 1 - Gear selector cable, with the help of a cable tie, pull it to the gear selector cable, connect to the mount
- 2 - Gear selection cable, connect to the mount, use a cable tie to tighten to the gear selector cable
- 3 - Sleeve
- 4 - gearshift housing
- 5 - Lock washer, do not damage the cable when disconnecting, be sure to replace
- 6 - Lock washer, do not damage the cable when disconnecting, be sure to replace
- 7 - Lock washer, do not damage the cable when disconnecting, be sure to replace
- 8 - Hexagon bolt, 20 Nm, 3 pcs., for fixing the support bracket
- 9 - Support bracket
- 10 - Bushing for fastening the support bracket to the gearbox
- 11 - Distance sleeve
- 12 - Cable fastening, after installation, adjust the gearshift mechanism, to fasten the gear shift cable to the gear lever, do not confuse the fastenings of the gear shift cable and the gear selection cable
- 13 - Lock washer, be sure to replace
- 14 - Cable fastening, after installation, adjust the gearshift mechanism, to fasten the gear selection cable to the gear selection lever, do not confuse the fastenings of the gear shift cable and the gear selection cable
- 15 - Hexagon nut, 23 Nm, must be replaced
- 16 - Gearshift lever with inertia damper, after installation, adjust the gearshift mechanism
- 17 - Gear selection lever, a short period of time from the moment of serial production: it was locked with a removable lock, the gear selection lever is removed together with the cable fastening, after installation, adjust the gear shift mechanism
- 18 - Slider
Mutual fixation of the cables of inclusion and selection of gear using a cable tie
The cable tie must be installed "eight" -arrow-. -A- = shift cable. -B- = gear selection cable
Disconnecting the gear selector cable attachment from the gear selector lever
Gear selector removed. Insert a slotted screwdriver -A- between bushing -B- and selector lever.
Installing the rope anchor
Gear selector removed. The cable anchor must only be attached to the bushing -arrow-. The cable attachment must be able to rotate easily with respect to the gear selection lever.
The fastener must be secured with a lock -arrow 2-.
Applicability of cable fasteners
Mounting position of the gear selector lever of the gear selector lever
1 - Gear shift lever with inertial damper
2 - The selector lever with slider -arrow- engages in the guide of the selector lever.
Installing the shift lever
When installing the selector lever on the shaft, align the groove of the lever -arrow A- with the protrusion of the shaft -arrow B-.
Removing the lock washer
Raise washer tab in direction -arrow-.
Visitor comments