- 1 - Engine compartment partition with a socket for mounting the support bracket
- 2 - Seal, must be replaced, between the support bracket and the engine compartment bulkhead, glued to the support bracket
- 3 - Support bracket for fastening the clutch pedal, in some versions with a noise-insulating casing
- 4 - Bolt
- 5 - Servo spring
- 6 - Bushing
- 7 - Support sleeve
- B - Clutch pedal
- 9 - Socket, for removal and installation, disconnect the master cylinder rod from the clutch pedal using pliers "T10005"
- 10 - Seal, must be replaced, between the clutch master cylinder and the support bracket
- 11 - Main cylinder, removed and installed after dismantling the support bracket -
- 12 - Clutch pedal position sensor "G476", can be checked in the 'guided fault finding' mode using the tester -VAS 5051-
- 13 - Clamp, when removing and installing the pipeline, pull the bracket out until it stops
- 14 - Hose to the tank
- 15 - Hexagonal self-locking nut, 25 Nm, 3 pcs., for securing the support bracket to the engine compartment bulkhead, must be replaced
- 16 - Hexagon nut, 25 Nm, must be replaced
- 17 - Clutch pedal stop
Support bracket with noise-insulating casing "arrow"
The original article is available at VWmanual.ru
Visitor comments