- 1 - Brake fluid expansion tank
- 2 - Seal, seals must be installed in the hose
- 3 - Hose to the tank
- 4 - Master cylinder
- 5 - Clamp, when removing and installing the pipeline, pull the bracket out until it stops
- 6 - Sealing ring, put on the pipeline fitting, lubricate with brake fluid during installation, sealing rings are selected depending on the design of the pipeline fitting
- 7 - Socket, for removal and installation, disconnect the master cylinder rod from the clutch pedal
- 8 - Clutch pedal
- 9 - Hexagon nut, self-locking
- 10 - Pipeline, to remove remove the battery together with the bracket
- 11 - Bracket, attached to the body
- 12 - Sealing ring, put on the pipeline fitting, lubricate with brake fluid during installation, sealing rings are selected depending on the design of the pipeline fitting
- 13 - Tee with bleed nipple
- 14 - Sealing ring, put on the pipeline fitting, lubricate with brake fluid during installation, sealing rings are selected depending on the design of the pipeline fitting
- 15 - Clamp, when removing and installing a pipeline or tee, pull it out until it stops
- 16 - Bleed nipple
- 17 - Protective cap
- 18 - Slave cylinder, can only be replaced with the gearbox removed
- 19 - Gearbox
Sealing rings for pipelines
| Pos. | Pipeline fitting design |
| 1 | Fitting with annular groove "arrow 1" |
| 2 | Nipple with thinning "arrow 2" |
Visitor comments