List of components and parts of the timing drive with technological notes on repair to drawing VC3.001:
1. Upper part of the timing belt housing.
2. The screw of fastening of a nave of a gear pulley of a camshaft: 100 Nm.
3. Screw securing the camshaft pulley to the hub: 25 Nm.
4. Camshaft pulley.
5. Hub with the driving rotor of the camshaft position sensor:
- when loosening and tightening, use an emphasis;
- Use a puller to remove.
6. Screw fastening the casing of the timing drive; 10 Nm.
- when assembling, replace with a new one.
7. Rear of the timing belt cover
8. Screw securing the rear part of the toothed belt cover 25 Nm.
9. Sealing sleeve.
10. Timing belt tensioner nut: 20 Nm and tighten 1/8 turn (45°).
11. Timing belt tensioner.
12. Guide roller nut: 20 Nm.
13. Guide roller.
14. Coolant pump.
15. Toothed pulley of the crankshaft.
16. Screw securing the crankshaft pulley: 120 Nm and tighten 1/4 turn (90°):
- when assembling, replace with a new one;
- when loosening and tightening, use an emphasis;
- do not additionally lubricate the thread and the supporting surface;
- turning by 90°can be performed in several stages.
17. Coolant pump mounting screw: 15 Nm.
18. The lower part of the casing of the toothed belt.
19. Vibration damper - crankshaft pulley:
- installation is possible only in one position (holes are offset).
20. Crankshaft pulley fastening bandage: 10 Nm and tighten 1/4 turn (90°).
21. Plug.
22. Toothed belt:
- before removal, mark the direction of movement;
- check wear;
- do not bend.
23. Lower screw securing the front engine mount bracket: 40 Nm and tighten 1/2 turn (180°):
- when assembling, replace with a new one.
24. The middle part of the casing of the toothed belt.
25. Front engine mount bracket.
Visitor comments