List of assemblies and parts installed on the cylinder block, with technological notes on repair to figure VC3.003:
1. Cylinder block.
2. Gasket:
- when assembling, replace with a new one.
3. Oil filter bracket.
4. Bracket mounting screw: 15 Nm and tighten 1/4 turn (90°):
- when assembling, replace with a new one;
- install the upper left and lower right screws first, then the rest and then tighten all four crosswise.
5. Bracket.
6. Oil filter bracket screw: 20 Nm.
7. Thermostat connection.
8. Screw for thermostat connection: 15 Nm.
9. O-ring:
- when assembling, replace with a new one.
10. Thermostat:
- check: by heating the thermostat in a container with water;
- start of opening: approx. 85°C:
- full opening: approximately 105°C;
- valve lift height: not less than 7 mm.
11. Hex Bolt:
- order and tightening torque.
12. Bracket for alternator and air conditioner compressor (in the presence of).
13. Poly V-belt tensioner.
14. 8V-ribbed belt tensioner fastening screw: 20 Nm.
15. Oil pan:
- before installation, clean the mating surfaces;
- apply sealant during installation.
16. Oil pan fixing screw: 15 Nm.
Visitor comments