Switch off the ignition. Disconnect the full load switch connector and connect an ohmmeter to the terminals of the block, which should show «infinity» (open circuit).
Fix goniometer 1 (pic. 2-204) on the throttle axis. Fully open throttle. In this case, the resistance on the ohmmeter should be zero (circuit is closed).
In this position, set the protractor needle to zero, then close the throttle by about 30°. The ohmmeter should show «infinity» (open circuit).
Slowly open the throttle until until the ohmmeter shows zero resistance. In this position, check the throttle valve opening angle. which should be within 10±2°. If the angle does not correspond to the specified value, adjust the position of the switch and repeat the test.
Visitor comments