To set the ignition timing, a stroboscope and a control tachometer are used.
Connect the stroboscope and tachometer in accordance with the operating instructions.
Start the engine, leave it to idle. Direct a flashing stream of strobe light into the hatch of the clutch housing. If the ignition timing is set correctly, then the alignment mark on the flywheel should be opposite the protrusion on the clutch cover. To adjust the ignition timing, loosen the lock nut of the distributor sensor flange and, turning the distributor sensor housing, align the marks.
Tighten the lock nut securing the ignition distributor flange.
Visitor comments