The power supply is disconnected, for example, when the battery is disconnected, when the radio is removed from the instrument panel, or when the radio fuse blows. When the car is equipped with the original VW radio equipment, the radio is specially matched to the car using a diagnostic tester. Therefore, coding of the radio is not required.
When installing a new radio or replacing the old one due to a malfunction, you should contact a workshop for the appropriate coding.
Attention! If the radio receiver is coded, then before disconnecting the battery or removing the receiver, it is necessary to check and write down the code. If the code is unknown, then only a specialized workshop can put the radio receiver into operation.
The individual code is specified in the operating instructions supplied with the radio. Do not keep the instructions in the car.
Removal
1. Disconnect the battery.
2. Remove the radio/heater panel trim, see the relevant chapter.
3. Unscrew the four screws (see arrows in the illustration) and pull the radio out of the mounting compartment as far as possible to disconnect the plugs located on the back of the radio.
4. Squeeze the plug leads (see arrows A in the illustration), move the locking spring 1 upwards (see arrow B) and disconnect the plug.
5. Unlock the plug (see arrow in illustration) and disconnect the antenna wire from the back of the radio.
Attention! Depending on the radio model, two antenna wires may be connected to it.
Installation
6. Connect the radio plugs and antenna wire and insert the radio into the mounting slot on the console. Do not press on the display or control buttons of the radio, as this may cause damage.
7. Screw in the four screws that secure the radio.
8. Reinstall the radio/heater panel trim, see the relevant chapter.
9. Connect the battery.
10. Enter the security code into the radio receiver, if required, and check its functionality.
Blaupunkt Dx-R4 radio with navigation system
Caution: To remove the receiver, you will need two V/160 removable brackets, which can be purchased at an auto parts store.
11. Insert both removable brackets 1 into the holes on the left and right sides of the front panel of the radio until they are locked in place (see illustration).
12. Remove the radio from the compartment on the instrument panel by pulling it towards you by the brackets (see arrows in illustration 40.11) and disconnect the plugs on the back of the receiver.
13. Remove the removable brackets from the removed radio. To do this, press the locking tabs on the radio inward.
14. Enter the security code after installing the radio.
Visitor comments