1 - pulley
2 - bolts (tightening torque 20 Nm)
3 - V-belt
4 - pressure pipe
5 - sealing ring
6 - hollow bolt (tightening torque 30 Nm)
7 - hose clamp
8 - inlet hose
9 - auxiliary pump
10 - bolt M8x32 (tightening torque 200 Nm)
11 - bolt M8x85 (tightening torque 25 Nm)
12 - bolt M8x50 (tightening torque 20 Nm)
13 - bolt M8x50 (tightening torque 25 Nm)
14 - bracket, mounted without mechanical stress
15 - swing bracket, mounted without mechanical stress
16 - bolt M10x98 (tightening torque 25 Nm)
17 - bolt M8x42 (tightening torque 20 Nm)
18 - bolt (tightening torque 20 Nm)
19 - adjusting bolt (tightening torque 20 Nm)
20 - mounting bracket
21, 23 - nuts (tightening torque 25 Nm)
22 - bolt (tightening torque 25 Nm)
24 - bracket
The pump shown is for a 2L 8 valve engine, but most of these parts may be found on these engines as well.
All recommended tightening torques must be observed during installation.
All removable spring rings and self-locking nuts must be replaced with new ones. Spare pumps are supplied without oil, i.e. before installation the pump must be filled with hydraulic oil G 002 00 and cranked several times so that the oil can be distributed.
Visitor comments