Dismantling the stabilizer (VW Golf 1)

Place the front of the car on supports. Both wheels should have uniformly reduced spring compression.

Unscrew 2 nuts from the fixing brackets of both triangular suspension arms.

At the rear support arms on both sides, unscrew 1 nut of the small mounting bracket.

Remove the stabilizer.

Before installation, check the condition of the rubber support of the stabilizer.

When installing the rear rubber supports, lubricate the holes with glycerin, then it will be easier to install them.

The information is available on the website VWManual

First insert the rear brackets into the corresponding eyes.

Tighten all nuts to a torque of 25 Nm.