Instruction: Welding or straightening of load-bearing or guiding elements of the suspension is not allowed. Self-locking nuts must be replaced. Corroded bolts/screws and nuts must always be replaced. Rubber-metal hinges (silent blocks) have a limited working range of twisting. Therefore, their fasteners must be tightened in such a position of the suspension, which is achieved with the curb weight of the car (those. when the wheel bearing housing is raised on a car hung on a lift).
- 1 - Nut, 65 Nm, when tightening, hold the ball joint pin at its inner polyhedron, self-locking, replace after each removal
- 2 - Stabilizer, various versions
- 3 - Stabilizer link, connects the stabilizer to the shock absorber
- 4 - Nut, 65 Nm, when tightening, hold the ball joint pin at its inner polyhedron, self-locking, replace. after every withdrawal
- 5 - Support bracket, with silent block
- 6 - Bolt, M10x70, 50 Nm and tighten by 90°, replace after each removal
- 7 - Bolt, M12x1.5x100, 70 Nm and tighten by 180°, replace after each removal
- 8 - Triangular lever, if damaged, replace together with ball joint
- 9 - Nut, M12x1.5, 60 Nm, self-locking, replace after each removal
- 10 - Ball joint, replaced as an assembly with a triangular lever if it is damaged
- 11 - Nut, 60 Nm, self-locking, replace after each removal
- 12 - Bolt, 70 Nm and tighten by 180°, 70 Nm and tighten by 90°, replace after each removal
- 13 - Bolt, M8x55, 20 Nm and tighten by 90°, replace after each removal
- 14 - Bolt, M12x1.5x110, 70 Nm and tighten by 180°, replace after each removal, tighten only in the position corresponding to the curb weight
- 15 - Bolt, M14x1.5x70, 100 Nm and tighten by 90°, tighten only after screwing the lower support of the power unit to the gearbox, replace after each removal
- 16 - Lower silent block of the lower support of the power unit
- 17 - Lower support of the power unit, first bolt to the gearbox, and then to the subframe, various designs
- 18 - Bolt, M10x75:50 Nm and tighten by 90°, M12x1.5x85:60 Nm and tighten by 90°, replace after each removal
- 19 - Bolt, M10x35:50 Nm and tighten by 90°, M12x1.5x50:60 Nm and tighten by 90°, replace after each removal
- 20 - Heat shield, front wheel drive vehicles only
- 21 - Bolt, 6 Nm
- 22- Bolt, M12x1.5x90.70 Nm and tighten by 180°, replace after each removal
- 23 - Subframe, various versions
- 24 - Upper silent block of the lower support of the power unit
Visitor comments