Instructions: Use brake filling and bleeder -VAS 5234- or VA.G 1869/4- to drain brake fluid from reservoir. Install spacer -VAG 1869/2- before removing brake caliper or brake hose (while lowering the pressure).
- 1 - Shield
- 2 - Brake disc, 286 mm, thickness: 12 mm, limit value: 10 mm, when worn, replace both brake discs of the axle at once, to remove, you must first dismantle the brake caliper and brake caliper
- 3 - Screw Togh, 4 Nm
- 4 - Screw, 90 Nm and tighten by 90°, replace after each removal
- 5 - Bracket with guides and sealing collars, supplied in grease assembly with guides as a single spare part, in case of damage to sealing collars or guides, install a repair kit. Use the supplied tube of grease when installing the guides
- 6 - Pad holder, always replaced when changing pads
- 7 - Brake shoe, thickness - 11 mm (excluding base plate thickness), limit: 2 mm excluding shim thickness, replace all chocks for the respective axle
- 8 - Brake shoe, thickness - 11 mm (excluding base plate thickness), limit: 2 mm excluding shim thickness, replace all chocks for the respective axle
- 9 - Pad holder, always replaced when changing pads
- 10 - Hex head screw, self-locking, 35 Nm, replace
- 11 - Brake caliper, to replace the brake pads, it is not necessary to unscrew the brake hose, after repair or replacement, it is necessary to carry out the basic installation
- 12 - O-ring
- 13 - Parking brake actuator
- 14 - Screw Togh, 12 Nm
- 15 - Bracket on the subframe
- 16 - Brake hose with fitting and hollow screw, 35 Nm, to brake caliper, to brake pipe, 14 Nm
- 17 - Mounting bracket
- 18 - Hexagon bolt, 12 Nm
Visitor comments