- 1 - ABS speed sensor, before installing the speed sensor, clean the hole and apply a little plastic refractory grease G 052112 AZ
- 2 - Hexagon socket head bolt, 8 Nm
- 3 - Wheel hub with bearing (bearing unit), magnetic ring for ABS sensor operation is built into the bearing
- 4 - Drive shaft
Removal and installation the wheel speed sensor on the front axle
Raise the vehicle. Disconnect connector "1" of the cable from the speed sensor. Unscrew bolt "2" from the steering knuckle. Remove the ABS speed sensor from the steering knuckle.
Installation
Before installing the speed sensor, clean the hole and apply a little high-melting plastic grease G 052 112 AZ to the sensor. Install the speed sensor in the hole of the steering knuckle and tighten the mounting bolt to a torque of 8 Nm. Connect the speed sensor connector.
[The original text is available on the portal VWManual]
Visitor comments